Lenovo ThinkPad SL300 User Manual
Page 51
Table 4. Staging-area behavior - Lenovo branded computers (continued)
Conditions on a Lenovo branded target computer prior to deployment
Maps deployed
Service partition
present
Description
Result from
deployment
Service partition - Front
Yes - Front
Service partition - Front
Yes - Back
Service partition - Back
Yes - Front
Service partition - Back
Yes - Back
• Create new
service partition
at the front of the
hard disk drive.
• Move the
necessary
modules from the
existing service
partition to the
new partition.
• Delete the old
service partition.
• Deploy the image.
• Delete all
unnecessary
modules and files
from the service
partition. Preserve
any Rapid Restore
files or Rescue and
Recovery files that
might exist.
• Resize the service
partition, if required.
• Deploy the Smart
Image as defined
by the base and
driver maps to the
service partition.
Base map and driver map (Front or back)
No
N/A
• Create the service
partition in the front
or at the back,
depending on the
base map.
• Deploy the Smart
Image as defined in
the base and driver
maps to the service
partition.
Base map only
Service partition - Front
Yes - Front
Service partition - Front
Yes - Back
Service partition - Back
Yes - Front
Service partition - Back
Yes - Back
• Create new
service partition
at the front of the
hard disk drive.
• Move the
necessary
modules from the
existing service
partition to the
new partition.
• Delete the old
service partition.
• Deploy the image.
• Create the service
partition in the front
or at the back,
depending on the
base map.
• Deploy all modules
defined in the base
map to the service
partition.
Note: If a driver map is
not used under these
conditions, setup
will use the native
Windows device
drivers and some
features might not be
enabled or optimized.
Chapter 3
.
Staging-area behavior and logic
37