Allied Telesis AT-S39 - Manual (Page 90)

90
3. Type 1 to select Trunk Ports.
The following prompt is displayed.
Enter Trunk Port(s) ->
4. Enter the ports that will constitute the port trunk and press Return.
You can specify the ports individually (e.g., 1,2,3,4) or as a range
(e.g., 7-10).
Once you have specified the ports of the trunk, the following
menu selection appears:
2 - Trunk Method ....... SA/DA trunking
You use this selection to specify the load distribution method. The
default is SA/DA.
5. To change the load distribution method, type 2 to toggle the
selection through its possible settings of SA/DA and SA only trunking.
The change in Port Trunking configuration is immediately activated
on the switch.
6. Type S to select Save Configuration Changes.
7. Configure the ports on the remote switch for port trunking.
8. Connect the cables to the ports of the trunk on the switch.
The port trunk is ready for network operation.