beautypg.com

Enabling and disabling port access control, Figure 57: port access control menu – Allied Telesis AT-S39 User Manual

Page 209

background image

AT-S39 User’s Guide

209

Enabling and Disabling Port Access Control

This procedure explains how to enable and disable port-based access
control on the switch. If you plan to activate the feature, there are two
things you need to do first. They are:

❑ Configure the RADIUS authentication protocol on the switch, as

explained in Configuring the Authentication Client Software
on page 196.

❑ Assign port roles and configure the parameter settings, as

explained in Configuring Port Access Control Parameters on
page 211.

To enable or disable 802.1x port-based access control, perform the
following procedure:

Note

You must use a local management session to configure port-based
access control. You cannot configure this feature through a Telnet
management session or enhanced stacking.

1. From the Main Menu, type 1 to select Port Menu.

The Port Menu is shown in Figure 12 on page 66.

2. Type 6 to select Port Access Control.

The Port Access Control menu is shown in Figure 57.

Figure 57 Port Access Control Menu

Allied Telesyn Ethernet Switch AT-8024 - AT-S39

Sales Switch

Login Privilege: Manager

Port Access Control

1 - Port Access Control .............. Enabled
2 - Authentication Method ............ RADIUS EAP
3 - Configure Port Access Parameters
4 - Display Port Access Parameters
5 - Display Port Access Status

S - Save Configuration changes
R - Return to Previous Menu

Enter your selection?