Allied Telesis AT-S39 User Manual
Page 55
AT-S39 User’s Guide
55
Returning the AT-S39 Software to the Factory Default Values
The procedure in this section returns all AT-S39 software parameters to
their default values. This procedure also deletes any VLANs you created
on the switch. The AT-S39 software default values can be found in
Appendix A, AT-S39 Default Settings on page 331.
Caution
Performing this procedure resets the switch. The switch will not
forward traffic during the brief period required to reload its
operating software. Some data traffic may be lost.
To return the AT-S39 management software to its default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type 7 to select Reset to
Factory Defaults.
The following prompt is displayed:
Are you sure you want to reset to Factory Defaults?
[Yes/No] ->
3. Type Y for yes or N for no.
The following prompt is displayed:
Do you want to reset IP, Subnet and Gateway as well?
[Yes/No] ->
4. If you type Y for yes, all switch parameters including the IP address,
subnet mask, and gateway address are changed to their default
values. If you type N for no, all switch parameters excluding those
settings are changed to their default values.
The following prompt is displayed:
The Factory Defaults take effect only after the
Switch reboots.
Do you want to proceed with switch reboot? [Yes/No]
->
5. Type Y to reset the switch.
The operating parameters are returned to their default values and
the switch is reset.