Allied Telesis AT-S39 - Manual (Page 109)

AT-S39 User’s Guide
109
6 - Config STP Port Settings
Configures the STP port parameters. For instructions, refer to
Configuring STP Port Settings on page 109.
8 - Reset STP to Defaults
Resets all STP bridge and port settings to their default values. This
option is available only when spanning tree is disabled on the
switch. For instructions on disabling spanning tree, refer to
Enabling or Disabling STP or RSTP on page 105.
3. After you have made the desired changes, type S to select Save
Configuration Changes.
4. To change STP port settings, go to the next procedure.
Configuring STP
Port Settings
To adjust a port’s STP parameters, perform the following procedure:
1. From the Spanning Tree Menu, type 3 to select STP Configuration.
2. From the STP Configuration menu, type 6 to select Config STP port
settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
3. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Ending Port to Configure [1 to 24] ->
4. To configure just one port, enter the same port number here as you
entered in the previous step. To configure a range of ports, enter the
last port of the range.