Allied Telesis AT-S39 - Manual (Page 327)

AT-S39 User’s Guide
327
Configuring TACACS+ and RADIUS
To configure the authentication protocols, perform the following
procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select System.
3. From the System page, select the Server-based Authentication tab.
The tab is shown in Figure 103.
Figure 103 Server-based Authentication Tab
Note
The Enable Server-based Authentication check box applies only to
the manager account feature. It does not apply to the 802.1x port-
based access control feature. If this option is disabled (no check in
box), which is the default setting, the switch uses its standard
Manager and Operator accounts when you log on to manage the
switch. If enabled, the switch uses the manager accounts on the
TACACS+ or RADIUS server.
4. To enable or disable the authentication feature on the switch, click
the Disable Server-based Authentication check box. A check in the
box indicates that this feature is disabled. No check indicate the
feature is enabled. The default is disabled.