Allied Telesis AT-S39 - Manual (Page 141)

AT-S39 User’s Guide
141
Modifying a VLAN
Note
To modify a VLAN, you need to know its VID. To view VLAN VIDs,
refer to the procedure Displaying VLAN Information on page 144.
To modify a VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 5 to select Configure VLANS.
3. From the Configure VLANS menu, type 2 to select Modify a VLAN.
The Modify a VLAN menu is shown in Figure 40.
Figure 40 Modifying a VLAN Menu
4. Type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [1 to 4096] ->
5. Enter the VID of the VLAN you want to modify. Press Return.
The Modify a VLAN menu for the selected VLAN is displayed. This
menu contains all relevant information about the VLAN.
6. Change the VLAN’s information as desired.
The menu selections are described below:
1 - VLAN Name
Use this selection to change a VLANs name. The name can be from
one to fifteen characters in length. The name should reflect the
function of the nodes that will be a part of the VLAN (for example,
Sales or Accounting). The name can contain spaces, but not special
characters, such as asterisks (*) or exclamation points (!).
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
Modify VLAN
1 - VLAN ID (VID) ........
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?