Allied Telesis AT-S39 - Manual (Page 236)

Section II: Local and Telnet Management
236
3. From the Administration Menu, type D to select Downloads &
Uploads.
The Downloads and Uploads menu in Figure 63 on page 224 is
displayed.
4. To upload the AT-S39 software image and bootloader from the
switch, type 3. To upload a configuration file, type 4.
The following prompt is displayed:
Upload Method/Protocol [X-Xmodem, T-TFTP]:
5. To upload a file using Xmodem, go to Step 6. Upload a file using TFTP,
do the following:
a. Type T.
The following prompt is displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
c. Enter the file name that the file is to be stored as on the TFTP
server.
Once the filename has been specified, the upload begins.
Uploading a configuration file takes only a few moments.
Uploading an AT-S39 image file can take several minutes.
6. To upload a file using Xmodem, do the following:
a. At the prompt is step 4, type X.
The following prompt is displayed:
You are going to invoke Xmodem upload utility:
Do you wish to continue? [Yes/No] ->
b. Type Y for Yes.
The following messages are displayed:
Use Hyper Terminal's 'Transfer/Receive File'
option to select Protocol
Note: Please select '1K Xmodem' protocol for
faster upload...
c. Begin the file transfer.
Note
The transfer protocol must be Xmodem or 1K Xmodem.