Figure 53: authentication menu (tacacs+) – Allied Telesis AT-S39 User Manual

Page 197

AT-S39 User’s Guide

197

5. To configure TACACS+, do the following:

a. Type 3 to select TACACS+ Configuration.

The following menu is displayed:

Figure 53 Authentication Menu (TACACS+)

b. Configure the settings as needed. The settings are described

below:

1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to
three network servers containing TACACS+ server software.
After you have entered an IP address, you will see the
following prompt:

Use per-server secret [Y/N] ->

If you will be specifying more than one TACACS+ server and if
all of the servers use the same encryption secret, you can
answer No to this prompt and enter the encryption secret
using the TAC Global Secret parameter.

However, if you are specifying only one TACACS+ server or if
the servers have difference encryption secrets, then respond
with Yes to this prompt. You will see:

Enter per-server secret [max 40 characters] ->

Use this prompt to enter the encryption secret for the
TACACS+ server whose IP address you are specifying.

Allied Telesyn Ethernet Switch AT-8024 - AT-S39

Sales Switch

Authentication Menu

1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Server Order .............. 1 2 3
5 - TAC Global Secret .............
6 - TAC Timeout ................... 30 seconds

S - Save Configuration Changes
R - Return to Previous Menu

Enter your selection?