Allied Telesis AT-S39 - Manual (Page 255)

AT-S39 User’s Guide
255
GET Community
SET Community
Trap Community
Use these parameters to set a switch’s SNMP community strings.
A community string can be up to thirteen characters. Community
strings are case sensitive and can contain spaces and special
characters, such as an exclamation point (!).
Trap Receiver 1
Trap Receiver 2
Trap Receiver 3
Trap Receiver 4
Use these selections to specify the IP addresses of up to four
management workstations on your network to receive traps from
the switch.
5. To configure SNMP management access of the switch, click the
Enable SNMP Access check box in the menu. If the check box is empty,
the switch cannot be managed through SNMP. This is the default.
When SNMP access is disabled, no one can manage the switch
remotely using an SNMP management program.
6. Click Apply to save your changes to the switch.
Changes are immediately activated on the switch.