Allied Telesis AT-S39 - Manual (Page 48)

Section II: Local and Telnet Management
48
4. Adjust the parameters as desired. To change a value, type its
corresponding number and, when prompted, enter the new value.
The parameters are described below.
1 - GET Community
2 - SET Community
3 - Trap Community
Use these parameters to set a switch’s SNMP community strings.
A community string can be up to thirteen characters. Community
strings are case sensitive and can contain spaces and special
characters, such as an exclamation point (!).
4 - Trap Receiver 1
5 - Trap Receiver 2
6 - Trap Receiver 3
7 - Trap Receiver 4
Use these selections to specify the IP addresses of up to four
management workstations on your network to receive traps from
the switch.
Changes to the SNMP parameters are immediately activated on
the switch.
5. After making your changes, type S to select Save Configuration
Changes.