beautypg.com

Configuring stp, Configuring stp bridge settings, Figure 88: stp bridge configuration menu – Allied Telesis AT-S39 User Manual

Page 287

background image

AT-S39 User’s Guide

287

Configuring STP

This section contains the following procedures:

Configuring STP Bridge Settings on page 287

Configuring STP Port Settings on page 289

Configuring STP

Bridge Settings

This section contains the procedure for configuring a bridge’s STP
settings.

Caution

The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. You should consult the IEEE 802.1w standard before
changing any of the RSTP parameters.

1. From the Spanning Tree tab menu, click STP Configuration and click

Configure.

The Spanning Tree menu is shown in Figure 88.

Figure 88 STP Bridge Configuration Menu