Allied Telesis AT-S39 - Manual (Page 258)

Section III: Web Browser Management
258
Returning the AT-S39 Software to the Factory Default Values
The procedure in this section returns all AT-S39 software parameters,
except the IP address, subnet mask, and gateway address, to their
default values. This procedure also deletes any VLANs that you have
created on the switch. The AT-S39 software default values can be found
in Appendix A, AT-S39 Default Settings on page 331.
Caution
Performing this procedure resets the switch. The switch will not
forward traffic during the brief period required to reload its
operating software. Some network traffic may be lost.
To return the AT-S39 management software to its default settings,
perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the System menu option.
3. Select the Factory Default tab. The Factory Default tab is shown in
Figure 76.
Figure 76 Factory Default Tab
4. Click the Reset Switch check box.
5. Click Apply.
A confirmation prompt is displayed.