Allied Telesis AT-S39 - Manual (Page 200)

Section II: Local and Telnet Management
200
3 - RADIUS Server 1 Configuration
4 - RADIUS Server 1 Configuration
5 - RADIUS Server 1 Configuration
Use these parameters to specify the IP addresses of up to
three network servers containing the RADIUS server software.
Selecting one of the options displays the following menu:
Figure 55 RADIUS Server Configuration
The options are described below:
1 - Server IP Address
Use this option to specify the IP address of a RADIUS server.
2 - Server Authentication UDP Port
Use this option to specify the UDP port of the RADIUS
protocol. The default is port 1812.
3 - Server Encryption Key
Use this option to specify the encryption key for the RADIUS
server.
c. Once you have finished configuring the settings in the RADIUS
Client Configuration menu, type R to return to the Authentication
Menu.
Note
Steps d. and e. do not apply to the 802.1x port-based access control
feature.
d. If you are configuring the RADIUS client software to use the new
manager account feature, type 1 to select Server-based
Authentication. This menu option is used to enable and disable
the manager account feature on the switch. If disabled, the switch
uses its standard Manager and Operator accounts when you log
on to manage the switch. If enabled, the switch uses the manager
accounts on the TACACS+ or RADIUS server. If you configured the
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
RADIUS Server 1 Configuration
1 - Server IP Address ................. 0.0.0.0
2 - Server Authentication UDP Port .... 1812
3 - Server Encryption Key ........
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?