Allied Telesis AT-S39 - Manual (Page 190)

Section II: Local and Telnet Management
190
Configuring the Interval Timer
To set the interval timer for the Broadcast Storm Control feature,
perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Configuration Menu, type A to select Advanced
Configuration.
3. From the Advanced Configuration Menu, type 2 to select Broadcast
Timers Setup. The Broadcast Storm Control menu is shown in Figure
51.
Figure 51 Broadcast Storm Control Menu
4. Type 1 or 2 and enter a value when prompted. The interval timer for
10 Mbps and 100 Mbps ports is in milliseconds and has a range of 10
to 120 milliseconds. The value should be entered in increments of 10
milliseconds.
The interval timer for 1000 Mbps ports is in microseconds and has
a range of 100 to 120000 microseconds. The value should be
entered in increments of 100 microseconds.
A value for an interval timer applies to all ports operating at the
corresponding speed.
Note
The 1000 Mbps speed applies only to optional Gigabit Ethernet
ports.
Your changes are immediately activated on the switch.
5. Once you have set the desired timer intervals, type S to select Save
Configuration Changes.
6. Go to the next procedure and specify the maximum number of
broadcast frames the ports on the switch can transmit.
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
Broadcast Storm Control
1 - Timer for 10/100 MB ports ..... 10 milli sec
2 - Timer for 1000 MB ports ....... 100 micro sec
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?