Allied Telesis AT-S39 - Manual (Page 196)

Section II: Local and Telnet Management
196
Configuring the Authentication Client Software
To configure the TACACS+ and RADIUS client software settings, perform
the following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
2. From the Administration Menu, type A to select Server-based
Authentication.
The Authentication Menu is shown in Figure 52.
Figure 52 Authentication Menu
Note
Option 1 - Server-based Authentication applies only to the manager
account feature described in this chapter. The menu option does
not apply to the 802.1x port-based access control feature. If this
option is disabled, the switch uses its standard Manager and
Operator accounts when you log on to manage the switch. If
enabled, the switch uses the manager accounts on the TACACS+ or
RADIUS server. If you want to disable the manager account feature,
toggle the menu option until it displays Disabled, which is the
default setting. Disabling Option 1 does not effect the 802.1x port-
based access control feature.
3. To select an authentication protocol, type 2 to select Authentication
Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active on the switch at a time.
If you selected TACACS+, go to Step 5. If you selected RADIUS, go
to Step 6.
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
Authentication Menu
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?