Allied Telesis AT-S39 - Manual (Page 239)

AT-S39 User’s Guide
239
Uploading Files from a Remote Management Session
This section contains the procedure for uploading a switch file from a
remote management session. The remote switch can be a switch that
you accessed through enhanced stacking or a switch where you started
a Telnet management session.
Note
To upload a file through enhanced stacking or a Telnet
management session, go to Uploading Files from a Remote
Management Session on page 239.
Please note the following before you begin the procedure:
❑ You must use TFTP when uploading a file through enhanced
stacking or a Telnet management session.
❑ The switch where you are uploading the file must have an IP
address and subnet mask. Consequently, you cannot use TFTP on
a slave switch of an enhanced stack unless the slave switch has an
IP address.
❑ There must be a node on your network that contains the TFTP
server software.
❑ You should start the TFTP server software before you begin the
upload procedure.
To remotely upload a switch file, perform the following procedure:
1. From the Main Menu of the switch from where you want to upload
the file, type 4 to select Administration Menu.
2. From the Administration Menu, type D to select Downloads &
Uploads.
The Downloads and Uploads menu is shown in Figure 63 on page
224.
3. To upload the AT-S39 image, type 3. To upload the configuration file,
type 4.
The following prompts are displayed:
Only TFTP uploads are available for a remote access
TFTP Server IP Address:
4. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name: