Allied Telesis AT-S39 - Manual (Page 291)

AT-S39 User’s Guide
291
Configuring RSTP
This section contains the following procedures:
❑ Configuring RSTP Bridge Settings on page 291
❑ Configuring RSTP Port Settings on page 293
Configuring
RSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. You should consult the IEEE 802.1w standard before
changing any of the RSTP parameters.
1. From the Spanning Tree tab menu, click RSTP Configuration and
click Configure.
The RSTP Bridge Configuration menu in Figure 90 is displayed.
Figure 90 RSTP Bridge Configuration Menu