Allied Telesis AT-S39 - Manual (Page 43)

AT-S39 User’s Guide
43
7 - Set Password
This parameter is used to change the Manager and Operator’s
login passwords. For instructions, refer to Configuring the
Management Passwords on page 51.
8 - BOOTP/DHCP
This selection activates and deactivates the BOOTP and DHCP
client software on the switch. For information on this selection,
refer to Activating the BOOTP and DHCP Client Software on
page 44.
9 - Reset Switch
This selection resets the switch, as explained in Resetting a
Switch on page 49.
A - Server-based Authentication
This selection is used to configure the TACACS+ and RADIUS
client software on the switch. For information on this feature, refer
to Chapter 17, TACACS+ and RADIUS Protocols on page 192.
Downloads and Uploads
For information on this selection, refer to Chapter 20, File
Downloads and Uploads on page 220.
R - Ping a Remote System
For information on this selection, refer to Pinging a Remote
System on page 54.
3. After you have set the parameters, type S to select Save Configuration
Changes.
Note
A change to any parameter in this menu, including IP address,
subnet mask, and gateway address, is immediately activated on the
switch.