Allied Telesis AT-S39 - Manual (Page 52)

Section II: Local and Telnet Management
52
Configuring
Management
Access
To configure the console timer, web access, and SNMP access security
features of the AT-S39 management software, perform the following
procedure:
1. From the Main Menu, type 5 to select System Config Menu.
The System Config Menu is shown in Figure 4 on page 46.
2. To configure the console timer, type 3 to select Console Disconnect
Timer Interval and, when prompted, enter a value of from 1 to 60
minutes. The default value is ten minutes.
For example, if you specify 2 minutes, the AT-S39 management
software automatically ends a local or remote management
session if it does not detect any activity from the management
station after 2 minutes.
A new console timer value takes affect the next time you start a
local or remote management session.
3. To configure web browser access, type 4 to select Web Server Status
and, when prompted, type E to enable the web server or D to disable
it. The default value is enabled.
For example, if you disable the web server, no one can manage
the switch remotely using a web browser.
4. To configure SNMP management access of the switch, type 5 to select
SNMP Access and, when prompted, type E to enable SNMP
management access or D to disable it. The default value is disabled.
When SNMP access is disabled, no one can manage the switch
remotely using an SNMP management program.
Your changes are immediately activated on the switch.
5. After you have made the desired changes, type S to select Save
Configuration Changes.