Allied Telesis AT-S39 - Manual (Page 289)

AT-S39 User’s Guide
289
Note
The aging time for BPDUs is different from the aging time used by
the MAC address table.
3. After you have made the desired changes, click Apply.
Configuring STP
Port Settings
To configure STP port settings, do the following:
1. From the Spanning Tree tab menu, click STP Configuration and click
Configure.
2. To adjust a port’s RSTP settings, click on a port in the switch image
and click Modify. You can select more than one port at a time.
The Port Spanning Tree Protocol menu is shown in Figure 89.
Figure 89 STP Port Configuration Menu
3. Adjust the settings as desired. The parameters are described below.
Participating
This parameter indicates whether the port is participating in the
spanning tree domain. You cannot change this value from a web
browser management session. It can be changed from a local or
Telnet management session, as explained in Configuring STP
Port Settings on page 109.