Allied Telesis AT-S39 - Manual (Page 46)

Section II: Local and Telnet Management
46
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and assign up
to four IP addresses of management stations to receive traps from the
switch, perform the following procedure:
Note
SNMP access is disabled by default. To enable SNMP access, refer to
Configuring Management Access on page 52.
1. From the Main Menu, type 5 to select System Config Menu.
The System Configuration Menu is shown in Figure 4.
Figure 4 System Configuration Menu
Allied Telesyn Ethernet Switch AT-8024GB - AT-S39
Sales Switch
Login Privilege: Manager
System Config Menu
1 - MAC Aging Time .................... 300 seconds
2 - Switch Mode ....................... Tagged
3 - Console Disconnect Timer Interval . 10 minute(s)
4 - Web Server Status ................. Enabled
5 - SNMP Access ....................... Disabled
6 - Console Startup Mode .............. Menu
7 - Reset to Factory Defaults
A - Advanced Configuration
R - Return to Previous Menu
Enter your selection?