Allied Telesis AT-S39 - Manual (Page 311)

AT-S39 User’s Guide
311
Adding Static Unicast and Multicast MAC Addresses
This section contains the procedure for assigning static unicast and
multicast address to ports on the switch. You can assign up to 255 static
MAC addresses per port.
To add a static unicast or multicast address to the MAC address table,
perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the MAC Address tab.
The MAC Address menu is shown in Figure 97 on page 308.
4. Click Add.
The Add Static MAC Address menu is shown in Figure 98.
Figure 98 Add Static MAC Address Menu
5. In the MAC Address section of the menu, enter the new static MAC
address. If you are adding a static unicast address, you can specify
only one port. If you are adding a static multicast address, you can
specify multiple ports.
6. In the graphical image of the switch click the port to which you want
to assign the address. A selected port turns white. You can select only
one port.
7. Click Apply.
8. Repeat this procedure to add other static addresses to the switch.