Allied Telesis AT-S39 User Manual
Page 273
AT-S39 User’s Guide
273
Speed
The operating speed of the port. Possible values are:
0010 - 10 Mbps
0100 - 100 Mbps
1000 - 1000 Mbps
Dplx
The duplex mode of the port. Possible values are half-duplex and
full-duplex.
Flow
The port’s flow control setting. Possible values are:
None - No flow control on the port.
Transmit - Flow control only on packets being transmitted out the
port.
Receive - Flow control only on packets being received on the port.
Both - Flow control for both packets entering and leaving the port.
BP
The port’s back pressure setting.
State
The operating status of the port. Possible values are Forwarding
and Disabled.
MAC Limit
The maximum number of MAC addresses the port can learn when
operating in the Limited security mode. This value is only
operational when the port is operating in the Limited security
mode.
PVID
The port VLAN identifier assigned to the port.
VlanID
The VID of the VLAN in which the port is an untagged member.
Priority Override
The status of the override priority feature. If the status is Yes,
tagged and untagged packets entering the port are directed to
either the low or high priority queue as specified in CoS. If the
status is No, tagged frames entering the port are directed to the
low or high queue according to the priority levels specified in the
tagged packets. For further information on this feature, refer to
Class of Service Overview on page 175.