Allied Telesis AT-S39 - Manual (Page 107)

AT-S39 User’s Guide
107
Configuring STP
This section contains the following procedures:
❑ Configuring STP Bridge Settings on page 107
❑ Configuring STP Port Settings on page 109
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
1. From the Spanning Tree Menu, type 3 to select STP Configuration.
The STP Menu is shown in Figure 29.
Figure 29 STP Menu
Allied Telesyn Ethernet Switch AT-8024 - AT-S39
Sales Switch
Login Privilege: Manager
STP Menu
The current protocol version is STP.
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
5 - Bridge Identifier ... 00:30:84:11:11:11
6 - Config STP Port Settings
7 - Display STP Port Settings
8 - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?