HP NonStop G-Series - Manual (Page 256)

Managing Your Spooler Jobs Using Peruse
Guardian User’s Guide — 425266-001
13- 8
Altering Job Attributes
When you enter the LIST command, use an asterisk (*) for the page number. Peruse
displays the page from the previous FIND command, which contains the error.
Continue using the FIND and LIST commands to find any remaining errors; if you don’t
specify a new string, FIND continues to search for the same string (*** ERRORS).
After you have found all errors, the FIND command displays only the Peruse prompt.
After making a note of your errors, you can delete the job with the DEL command, exit
Peruse, and correct your TFORM document.
Altering Job Attributes
You can use several Peruse commands to change the attributes of your spooler jobs. You
can change the number of copies to be printed, change the location for a job, or change
the report name with the COPIES, LOC, and REPORT commands.
For example, this command string increases the number of copies to 10, changes the
location to #HT09, and sets the report name to MEMO:
The JOB command shows that the changes have been made to the job:
Printing Part of a Job
You can print selected pages of a spooler job with the LIST command. For example, the
following command prints the first eight pages and page 14 of job 534:
The LIST command creates job 560 and leaves job 534 unchanged. The C option
preserves form-control information for job 560, such as overprinting of lines for
boldface and underscores.
_COPIES 10; LOC #HT09; REPORT MEMO
_JOB
JOB BATCH STATE PAGES COPIES PRI HOLD LOCATION REPORT
J 534 READY 20 10 4 #HT09 MEMO
_LIST /OUT $S.#LP3/ 1/8, 14 C
_JOB
JOB BATCH STATE PAGES COPIES PRI HOLD LOCATION REPORT
J 534 READY 20 10 4 #HT09 MEMO
560 OPEN 1 4 #LP3 MEMO