HP NonStop G-Series - Manual (Page 313)

Managing the Spooler Using Spoolcom
Guardian User’s Guide — 425266-001
15 -13
Modifying Print Device Attributes
A listing such as this is displayed on your home terminal:
Modifying Print Device Attributes
1. Drain the device to take it offline:
) DEV $device, DRAIN
Device attributes can be changed only when the device is offline.
2. Specify the device attributes:
) DEV $device device-attribute ...
Device attributes are described in Table 15-5 on page 15-15.
3. Put the device back online:
) DEV $device, START
Example
To change the form name assigned to the device named $PRINT, enter:
) DEV $PRINT, DRAIN
) DEV $PRINT, FORM LETTERH
) DEV $PRINT, START
Now, only jobs that specify form LETTERH will print on this device; all other jobs sent
to this device remain in the device queue.
DEVICE: $LP
STATE: BUSY
LAST ERROR: %004014
EXCLUSIVE: OFF !
FIFO: OFF
HEADER: ON
TRUNCATION: OFF
DRAINING: NO
PRINTING JOB: 1199
PARM: 0
PROCESS: $SPLA
RETRY: 5
TIMEOUT: 4096
SPEED: 700
WIDTH: 900
FORM:
RESTART: 120
DEVRESET: OFF
DEVTYPE:
STARTFF: OFF !
ENDFF: ON
CHARMAP: NONE
PREXLATE: OFF
LUTOFVALUE: CRFFCR
LUEOLVALUE: CRLF
LUEOLUHEN: LT132