Naming spooler components and files, Table 15-1, Spooler naming conventions – HP NonStop G-Series User Manual
Page 302
Managing the Spooler Using Spoolcom
Guardian User’s Guide — 425266-001
15- 2
Naming Spooler Components and Files
Naming Spooler Components and Files
If you name a spooler component or file, observe the guidelines in
, which
allow for expansion of the file name across the network.
Note. All spooler components, including the supervisor, collectors, print processes, and data
files for the collectors, should reside on a single system. Output devices can reside elsewhere.
Table 15-1. Spooler Naming Conventions
File or
Component Comments
Collector
process name
The name is $
process
and has up to four alphanumeric characters. The
first character is a letter. For example: $S2. There is no default name.
Collector
program name
The default name is $SYSTEM.SYSTEM.CSPOOL. Replace the file if
you want to run your own collector process.
Command files
The file name consists of eight alphanumeric characters. There is no
default name.
Configuration
file
The file name has up to eight alphanumeric characters. There is one file for
each spooler, and no default name. For example:
$SYSTEM.SPLUTIL.SPLCONF.
Control files
The file name has seven alphanumeric characters. The first character must
be a letter. The spooler adds a numeric character to the end of the file
name. There is no default name. For example: $MKT.SPL.SPL
n
.
Data files
The file name has eight alphanumeric characters. There is one file for each
collector, and no default name. For example: $MKT.SPL.SPLDATA.
Device name
The name is $
device
and has up to six alphanumeric characters. The first
character is a letter. There is no default name. For example: $SLOW.
Location name
The logical destination of a job, consisting of two names separated by a
period—the group name and the destination name, as follows:
Group name
The group name is #
group
and has one through seven alphanumeric
characters starting with a letter. If you do not specify a group name, your
output is sent to the group named #DEFAULT. Group names must always
begin with the # character.
Destination
name
The destination name is
dest
and has up to eight alphanumeric characters.
The first character is a letter. If you do not specify a destination name, your
output is sent to the destination named DEFAULT.
Print process
name
The name is $
process
and has up to four alphanumeric characters. The
first character is a letter. There is no default name. For example, $USRP.
Print program
name
The default name is $SYSTEM.SYSTEM.PSPOOL. Replace the file if you
want to run your own print process.
Supervisor
process name
The name is $
process
and has up to four alphanumeric characters. The
first character is a letter. The default name is $SPLS.