Allied Telesis RAPIER I User Manual
Software version 2.8.1
This manual is related to the following products:
Table of contents
Document Outline
- Software Version 2.8.1
- Introduction
- Upgrading to Software Version 2.8.1
- Overview of New Features
- System Enhancements
- Command Line Interface (CLI) Enhancements
- File System Enhancement
- Switching Enhancements
- Ordering Hardware Filters in 48-Port Switches
- Limiting Rapid MAC Movement
- Route Update Queue Length
- Removing a Description from a Switch Port
- Securing a Single VLAN through Switch Filters
- Change of Debug Command Syntax
- Enhanced Static Switch Filtering on Ports within a Trunk Group
- Ethernet Protection Switching Ring (EPSR)
- Command Reference Updates
- create switch trunk
- disable switch debug
- disable switch filter vlansecure
- disable switch port vlan
- enable switch debug
- enable switch filter vlansecure
- enable switch port vlan
- set lacp
- set switch hwfilter mode
- set switch hwrouteupdate
- set switch port
- set switch thrashlimit
- set switch trunk
- show lacp
- show switch
- show switch debug
- show switch filter
- show switch hwfilter
- show switch port
- PPPoE Access Concentrator
- MSTP Enhancement
- STP Enhancement
- Asynchronous Port Enhancement
- Internet Group Management Protocol (IGMP) Enhancements
- Internet Protocol (IP) Enhancements
- Expanded number of Eth interfaces per physical interface
- Expanded IP Troubleshooting
- IP Route Preference Options
- IPv4 Filter Expansion
- Enhancements to Display of UDP Connections over IPv4
- Waiting for a Response to an ARP Request
- Adding Static ARP Entries with Multicast MAC Addresses
- Enhanced Static ARP Entry Filtering on Ports within a Trunk Group
- Command Reference Updates
- IPv6 Enhancements
- L2TP Enhancements
- Open Shortest Path First Enhancements
- BGP Enhancements
- MLD and MLD Snooping Enhancements
- Extension to Range of Classifier fields for x900 Switches
- QoS Enhancements
- Port Groups
- Storm protection
- Command Reference Updates
- add qos portgroup port
- create qos policy
- create qos portgroup
- create qos trafficclass
- delete qos portgroup port
- destroy qos portgroup
- reset qos portgroup counters
- set qos policy
- set qos portgroup
- set qos trafficclass
- show qos policy
- show qos port
- show qos portgroup
- show qos portgroup counters
- show qos trafficclass
- Secure Copy (SCP)
- SSL Counter Enhancement
- Firewall Enhancements
- Enhancements to IPsec/VPN
- SNMP MIBs
- CDP over WAN Interfaces
- Permanent Assignments on AR400 Series Routers
- Ethernet Protection Switching Ring (EPSR)