Allied Telesis RAPIER I - Manual (Page 87)

Software Version 2.8.1 87
Software Version 2.8.1
C613-10477-00 REV B
show l2tp ip
Syntax SHow L2TP IP
Figure 24: Example output from the show l2tp ip command
show l2tp tunnel
Syntax SHow L2TP TUNnel[=1..65535]
Figure 25: New option in example output from the show l2tp tunnel command
L2TP IP Range Information
------------------------------------------------------------
IP Range ........................ 192.168.1.2
PPP template .................. 1
Sequence numbering ............ off
Pre-draft 13 support .......... off
ToS Reflect ................... off
Proxy Authentication .......... on
------------------------------------------------------------
Table 22: Parameters in the output of the show l2tp ip command
Parameter Meaning
Proxy Authentication Whether the router or switch, acting as an LNS, performs
Proxy Authentication for the PPP user if the LAC provides
Authentication information; one of “on” or “off”.
Tunnel ID ..................... 3
State ....................... established
Started ..................... 08-Apr-2006 11:04:50
Debug ....................... decode
.
.
.
Table 23: Parameters in the output of the show l2tp tunnel command
Parameter Meaning
Debug Whether debugging is “disabled” or enabled on the tunnel.
If enabled, the type of debugging is displayed; one of
“state”, “packet” or “decode”.