Allied Telesis RAPIER I - Manual (Page 103)

Software Version 2.8.1 103
Software Version 2.8.1
C613-10477-00 REV B
Enable and Disable Backoff
BGP backoff can now be enabled or disabled using the commands enable bgp
backoff
and disable bgp backoff. BGP backoff is disabled by default, however
it automatically enables the first time a peer is added.
Command Changes
The following table summarises the new and modified commands:
BGP Peer and Peer Template Enhancements
The option none has been added to the following parameters in the peer and
peer template commands:
■ description
■ inroutemap
■ outroutemap
The addition of none to these parameters allows you to not specify a
description or route map, and to remove a previously specified description or
route map.
peer definitions The enhanced parameters:
add bgp peer=ipadd [description={none|description}]
[inroutemap={none|routemap}]
[outroutemap={none|routemap}] [other options]
set bgp peer=ipadd [description={none|description}]
[inroutemap={none|routemap}]
[outroutemap={none|routemap}] [other options]
peertemplate
template definitions
The enhanced parameters:
add bgp peertemplate=1..30 [description={none|description}]
[inroutemap={none|routemap}]
[outroutemap={none|routemap}] [other options]
set bgp peertemplate=1..30 [description={none|description}]
[inroutemap={none|routemap}]
[outroutemap={none|routemap}] [other options]
Command Change
disable bgp backoff New command
enable bgp backoff New command
set bgp backoff New low parameter
show bgp backoff New disabled option for state parameter
Modified normal, backed off, and peer disabled options
for state parameter
New mem upper threshold value parameter
New upper notify parameter
New mem lower threshold value parameter
New lower notify parameter