Allied Telesis RAPIER I - Manual (Page 100)

100 Open Shortest Path First Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
show ospf area
Syntax SHow OSPF AREa[={BAckbone|area-number}] [{FULl|SUMmary}]
where area-number is a 4-byte OSPF area number in dotted decimal notation
Description The output of this command includes new fields.
Figure 27: Example output from the show ospf area command for a specific area
Area 0.0.0.1:
State ......................... Active
Authentication .... ........... Password
Stub area ..................... No
Stub cost ..................... 1
NSSA .......................... Yes
Role ........................ CANDIDATE
Stability Interval .......... 40
State ....................... DISABLED
Summary LSAs .................. Send
SPF runs ...................... 23
Area border router count ...... 3
AS border router count ........ 2
LSA count ..................... 10
LSA sum of checksums .......... 345bf
Ranges:
Range ....................... 192.168.25.0
Mask ...................... 255.255.255.0
Range ....................... 192.168.250.0
Mask ...................... 255.255.255.0
Interfaces:
ppp23:
Type ...................... Point to point
State ..................... ptp
eth0:
Type ...................... Broadcast
State ..................... otherDR
Table 25: New parameters in output of the show ospf area command for a specific area
Parameter Meaning
Role NSSA translator role; one of “CANDIDATE” or “ALWAYS”.
This field is only displayed when NSSA is “Yes”.
Stability Interval Time period, in seconds, that the router or switch will
continue to translate Type-7 LSAs after losing its elected
translator role to another NSSA border router. This field is
only displayed when NSSA is “Yes”.
State Current NSSA translator state. If Role is “ALWAYS”, one of
“DISABLED” or “ENABLED”. If Role is “CANDIDATE”, one
of “DISABLED” or “ELECTED”. This field is only displayed
when NSSA is “Yes”.