Allied Telesis RAPIER I - Manual (Page 123)

Software Version 2.8.1 123
Software Version 2.8.1
C613-10477-00 REV B
Figure 37: Example output from the show classifier command (Layer 3 byte data)
Figure 38: Example output from the show classifier command (MAC address)
Classifier Rules
------------------------------------------------------------
Rule .................. 2222
D-MAC Address ........ aa-bb-cc-dd-ee-ff
S-MAC Address ........ aa-bb-cc-dd-ee-ff
M-Type ............... L2UCAST
VLAN ................. vlan1234 (1234)
E-Format ............. SNAP
Protocol ............. 1234567890 (-)
Layer 3 Byte 01:
Offset ............. 0
Value .............. 50
Layer 3 Byte 02:
Offset ............. 1
Value .............. 4f
Layer 3 Byte 03:
Offset ............. 2
Value .............. 53
Layer 3 Byte 04:
Offset ............. 3
Value .............. 54
Mask ............... fc
------------------------------------------------------------
Classifier Rules
------------------------------------------------------------
Rule .................. 2222
D-MAC Address ........ aa-bb-cc-dd-ee-ff
S-MAC Address ........ aa-bb-cc-dd-ee-ff
M-Type ............... L2UCAST
VLAN ................. vlan1234 (1234)
E-Format ............. SNAP-TAGGED
Protocol ............. 1234567890 (-)
------------------------------------------------------------
Table 30: New parameters in output of the show classifier command
Parameter Meaning
D-MAC Addr
mask A MAC address that specifies a 48-bit binary mask to apply to the
destination MAC address before determining a match. A 1 in the mask
means that the value of the bit in that position is used to determine a
match, and a 0 means that the bit is ignored. The default mask value is
ff-ff-ff-ff-ff-ff.
S-MAC Addr
mask A MAC address that specifies a 48-bit binary mask to apply to the source
MAC address before determining a match. A 1 in the mask means that
the value of the bit in that position is used to determine a match, and a 0
means that the bit is ignored. The default mask value is ff-ff-ff-ff-ff-ff.
ICMP Code The ICMP message reason code to match against the ICMP code field in
an ICMP packet header. A decimal value is shown, with an equivalent
parameter option in brackets if available.
ICMP Type The ICMP message type to match against the ICMP type field in an ICMP
packet header. A decimal value is shown, with an equivalent parameter
option in brackets if available.