Allied Telesis RAPIER I - Manual (Page 139)

Software Version 2.8.1 139
Software Version 2.8.1
C613-10477-00 REV B
Example To display all configured port groups, use the command:
sh qos portg=all
show qos portgroup counters
Syntax SHow QOS PORTGroup[={group-list|ALL}] COUnters
TRafficclass[={trafficclass-list|DEFault|ALL}]
Description This new command displays information about traffic class counters for port
groups
.
Table 33: Parameters in output of the show qos portgroup command
Parameter Meaning
ID/Identifier Port group ID.
Description Description of the port group.
Policy
Assigned/Policy
Assigned to Policy attached to the port group.
Ports Ports that belong to the port group.
Parameter Meaning
PORTgroup Specifies a port group for which to display information.
Default: all
group-list
Integer from 1 to 32.
ALL All port groups.
no value Displays summary information about all port groups.
TRafficclass Traffic class attached to the port group ( Figure 42 , Table 34 ).
Default: all
trafficclass-list A specific traffic class that consists of:
• one or more traffic classes
• a range specified with a hyphen, such as 1-4
• a comma-separated list of numbers and/or ranges
• an integer from 0 to 1023
DEFault The default traffic class.
ALL Displays counters for all traffic classes.