Allied Telesis RAPIER I - Manual (Page 75)

Software Version 2.8.1 75
Software Version 2.8.1
C613-10477-00 REV B
show ip
Syntax SHow IP
Figure 16: Modified example output from the show ip command
Figure 17: Modified example output from the show ip command
IP Module Configuration
------------------------------------------------------------
Module Status .................. ENABLED
IP Packet Forwarding ........... ENABLED
IP Echo Reply .................. ENABLED
Debugging ...................... DISABLED
IP Fragment Offset Filtering ... ENABLED
Default Name Servers
Primary Name Server .......... 192.168.1.1 (ppp0)
Secondary Name Server ........ Not Set
Name Server .................... 192.168.1.1 (ppp0)
Secondary Name Server .......... Not Set
Source-Routed Packets .......... Discarded
Remote IP address assignment ... DISABLED
DNS Relay ...................... DISABLED
IP ARP LOG ..................... ENABLED
IP ARP refresh by hit .......... ENABLED
IP/MAC address disparity........ DISABLED
.
.
.
.
.
.
Routing Protocols
RIP Neighbours ................. 0
EGP Status ..................... DISABLED
Autonomous System Number ....... Not Set
Transfer RIP to EGP ............ Disabled
ARP aging timer multiplier...... 4 (1024-2048 secs)
Arp wait timeout ............... 1 secs
.
.
.
Table 15: Modified parameters on output of the show ip command.
Parameter Meaning
IP/MAC address disparity Whether the router or switch accepts packets with
conflicting IP and MAC addresses, and allows ARP entries
with multicast MAC addresses. One of “ENABLED” or
“DISABLED”.