Allied Telesis RAPIER I - Manual (Page 35)

Software Version 2.8.1 35
Software Version 2.8.1
C613-10477-00 REV B
Example To disable the default vlan on port 1, use the command:
dis swi po=1 vlan=1
enable switch debug
Syntax ENAble SWItch DEBug={ARL|DEV|DMA|PHY|ALL} [OUTPUT=CONSOLE]
[TIMEOUT={1..4000000000|NONE}]
Description The m6 parameter is now replaced by the dev parameter in this command.
enable switch filter vlansecure
Syntax ENAble SWItch FILter VLANSecure
Description This new command returns Layer 2 switch filtering to its default behaviour by
enabling vlansecure mode. The vlansecure mode is enabled by default.
When vlansecure mode is enabled and a filter exists for a given host and port,
moving the host to a different port blocks the host completely. When
vlansecure
mode is disabled and a filter exists for a given host and port,
moving the host to a different port in the same VLAN only stops the host from
accessing that VLAN, not other VLANs.
Example To turn on the default filtering behaviour, use the command:
ena swi fil vlan
enable switch port vlan
Syntax ENAble SWItch POrt={port-list|ALL}
VLAN[={vlan-name|1..4094|ALL}]
where:
■ port-list is a port number, range (specified as n-m), or comma-separated list
of numbers and/or ranges. Port numbers start at 1 and end at m, where m
is the highest numbered Ethernet switch port, including uplink ports.
■ vlan-name is a unique name from 1 to 32 characters. Valid characters are
uppercase and lowercase letters, digits, the underscore, and hyphen.
Description This new command enables one or more ports for VLANs to which they
belong. A port is automatically enabled for a VLAN when it is added to that
VLAN, however, it can be disabled using the disable switch port vlan
command, or automatically disabled by thrash limiting or QoS protection.
The port parameter specifies the port or ports to enable. If a trunked port is
specified, all ports in the trunk are enabled.
Debug Option Description
DEV Debugging is disabled for operations related to the switch chip.