Allied Telesis RAPIER I - Manual (Page 161)

Software Version 2.8.1 161
Software Version 2.8.1
C613-10477-00 REV B
Command Changes
The following table summarises the new and modified commands:
Displaying SIP ALG Session Details
This Software Version allows you to display configuration details for the SIP
ALG, and details about the SIP sessions that are using the SIP ALG on the
router or switch. Use the new command:
show firewall sipalg ip=ipadd[-ipadd]|
[callid=call-id]|[counter]|[summary]
To show counters for the SIP sessions using SIP ALG, use the command:
show firewall sipalg counter
To reset the counters that are displayed with the show firewall sipalg counter
command, use the command:
reset firewall sipalg counter
Command Changes
The following table summarises the new and modified commands:
Firewall Policy Rules Expansion
This Software Version increases the total number of rules and application rules
(apprules) that a firewall policy can associate with an interface to 2099. In
previous Software Versions the maximum number was 699.
The rules and apprules are cumulative. That is, a policy cannot assign more
than 2099 rules and apprules combined to an interface.
Firewall policy rules and apprules are created with the commands add firewall
policy apprule
and add firewall policy rule. The range of ID numbers you can
specify for a rule or apprule is unchanged from 1 to 4294967295.
Command Changes
This expansion does not affect any commands.
Command Change
set firewall sipalg New command.
Command Change
reset firewall sipalg counter New command.
show firewall sipalg New command.
show firewall sipalg counter New command.