Allied Telesis RAPIER I - Manual (Page 10)

10 System Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
To capture data when the CPU is experiencing a specific amount of
instantaneous usage, set the start and start percentages with the command:
activate cpu extended start=1..100 [stop=1..100]
When a start percentage is set, the router or switch automatically disables
extended monitoring once it has 500 data entries.
To enable extended monitoring, use the command:
enable cpu extended
This command also lets you capture data immediately, without first setting
start and stop percentages. This adds data entries continuously, until you stop
it. Only the last 10 seconds of data entries are stored.
To stop capturing data, and reset the start and stop parameters if they are set,
use the command:
disable cpu extended
To remove data entries and reset the start and stop parameters in the activate
cpu extended
command, use the command:
reset cpu utilisation
This command interrupts active data capturing for a specific event. However,
monitoring remains enabled, and continues to collect data. This means you can
capture data for a particular event without having to disable and re-enable this
feature.
Command Changes
The following table summarises the new and modified commands:
Command Change
activate cpu extended New command.
disable cpu extended New command.
enable cpu extended New command.
reset cpu utilisation Modified command.
show cpu New extended parameter in command.
New output field when extended parameter is used.