Allied Telesis RAPIER I - Manual (Page 216)

18 create epsr Software Reference
Examples To create an EPSR instance called blue, with this switch acting as the master
node, vlan2 as the control VLAN, and port 1 as the primary port, use the
command:
cre epsr=blue mode=mast con=vlan2 pri=1
Related Commands add snmp targetaddr (SNMPv3)
add snmp targetparams (SNMPv3)
create snmp community (SNMPv1 & v2)
create vlan
destroy epsr
set epsr
set epsr port
show epsr
CONtrolvlan The identifier of the control VLAN.
Note that you must first create the VLAN specified. To do this, use the
create vlan command. For details of this command, see the Switching
Chapter of your switch’s Software Reference.
Default: no default
vlan-name A unique name for the control VLAN. This name can be from
1 to 32 characters long. Valid characters are uppercase and
lowercase letters, digits, the underscore, and the hyphen.
The vlan-name cannot be a number or ALL.
1..4094 The VID of the control VLAN
PRImaryport The port number of the primary port for the EPSR instance on this switch.
Only configured for the master node.
Default: no default
HEllotime The rate that the master node transmits its TAPS protocol health control
messages. The time can be specified from 100 milliseconds (100ms), to
32767 seconds (32767s). Only configured for the master node.
If no unit suffix is specified, the value is read as seconds. If ms is specified,
the value must be a multiple of 100 ms.
Default: 1s
FAilovertime The time period that a master node allows for a healthcheck frame to circle
the loop before declaring that the EPSR ring has broken. This time period is
measured from the time the frame leaves the master node’s primary port,
to the time it is received at the master node’s secondary port.
The time2 can be specified from 200 milliseconds (200ms) to 65535
seconds (65535s). If no unit suffix is specified, the value is read as seconds.
If ms is specified, the value must be a multiple of 100 ms.
The failovertime must be at least twice the value of the hellotime.
Default: 2s
RIngflaptime The minimum number of seconds that a master node must remain in the
failed state (before moving to the complete state), even if the ring has
recovered from its fault condition. This delay is to limit unnecessary blocking
and unblocking of the secondary port when a link in the ring is flapping
(intermittently recovering from its fault).
Default: 0
TRap Whether SNMP traps will be sent when the EPSR instance changes state.
Default: enabled
ENAbled Traps will be sent as long as the SNMP module is
appropriately configured.
DIsabled Traps will not be sent.
Parameter Description (cont.)