Allied Telesis RAPIER I - Manual (Page 196)

196 CDP over WAN Interfaces Release Note
Software Version 2.8.1
C613-10477-00 REV B
show lldp cdp
Syntax SHow LLDP CDP
Description This command displays general information about the current CDP set up.
Figure 64: Example output from the show lldp cdp command
show lldp cdp interface
Syntax SHow LLDP CDP INTerface[=interface]
where interface is one of the following:
■ ethn
An Eth port, where n is the Ethernet port instance (for example, eth0)
■ portm
A switch port, where m is the port number (for example, port2 for the
switch port numbered 2)
■ pppm
A PPP interface, where m is the interface number
Description This command displays information about the interfaces on which CDP is
currently enabled.
Figure 65: Example output from the show lldp cdp interface command
CDP general information
---------------------------------------------
Enabled ...................... Yes
Number of CDP neighbours ..... 14
SysUpTime .................... 12345.42s
CDP processing time .......... 3.385727s
PPP Templates Enabled ........ 1,4
PPP Templates Disabled ....... 2,3
Triggers:
CDP neighbour add .......... -
CDP neighbour remove ....... 5
---------------------------------------------
Table 55: New parameters in output of the show lldp cdp command
Parameter Meaning
PPP Templates Enabled A list of the PPP templates, by number, that are enabled for
CDP listening.
PPP Templates Disabled A list of the PPP templates, by number, that are disabled for
CDP listening.
CDP interface information
-------------------------
Name Status
-------------------------
port1 Down
port2 Up
port3 Down
ppp0 Up
ppp1 Up
-------------------------