Allied Telesis RAPIER I - Manual (Page 43)

Software Version 2.8.1 43
Software Version 2.8.1
C613-10477-00 REV B
show switch debug
Syntax SHow SWItch DEBug
Figure 7: Example output from the show switch debug command
Table 5: New parameters in the output of the show switch command
Parameter Meaning
Learn delay Number of milliseconds that the switch waits after the last IP
route is inserted before it starts to update the hardware
routing system.
Queue size The number of entries currently in the hardware route update
queue.
Queue limit The maximum number of entries that the queue can hold.
Percent in use The percentage of the queue limit that is currently used.
High water mark The highest number of messages that have been seen on the
queue since the switch last started up.
Queue maximum The maximum value to which you can set the queue size. This
depends on the amount of memory installed on the switch.
Queue default The default maximum number of entries in the queue. This
depends on the amount of memory installed on the switch.
Updating hardware (status) The number of entries that the software has queued for
writing into the hardware table, followed by the status. Status
is Pending if the hardware is not currently processing queued
routes and Active if it is currently processing the routes.
Enabled Switch Debug Modes Output Timeout
----------------------------------------------------------
DEV 16 12345
----------------------------------------------------------
Table 6: Parameters in output of the show switch debug command
Parameter Meaning
Enabled Switch Debug Modes Whether the debugging option for the router or switch is
ARL, DMA, DEV, PHY, or None.