Allied Telesis RAPIER I - Manual (Page 12)

12 System Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
reset cpu utilisation
Syntax RESET CPU UTIlisation
Description This command, which resets all CPU utilisation percentages, has been
modified to include resetting any start and stop percentages set with the
activate cpu extended
command. It also removes any data captured during
extended utilisation monitoring, and clears this output from the show cpu
command.
Example To reset the CPU utilisation, use the command:
reset cpu util
set system contact
Syntax SET SYStem CONtact={contact-name|NONE}
The contact parameter specifies the contact name, which is:
■ displayed in the output of the show system command
■ stored in the MIB object sysContact
If the new option none is specified, no contact name is defined. Any existing
contact name is cleared. The default is none.
set system location
Syntax SET SYStem LOCation={location|NONE}
The location parameter specifies the location of the router or switch, which is:
■ displayed in the output of the show system command
■ stored in the MIB object sysLocation
If the new option none is specified, no location is defined. Any existing
location is cleared. The default is none.
set system name
Syntax SET SYStem NAMe={name|NONE}
The name parameter specifies the system name of the router or switch, which
is:
■ displayed in the output of the show system command
■ displayed in the CLI prompt so you know which router or switch you are
configuring
■ stored in the MIB object sysName
If the new option none is specified, no name is defined. Any existing name is
cleared. The default is none.