Allied Telesis RAPIER I - Manual (Page 84)

84 L2TP Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
Command Reference Updates
This section describes each new command and the changed portions of
modified commands and output screens. For modified commands and output,
new parameters, options and fields are shown in bold.
add l2tp ip
Syntax ADD L2TP IP=ipadd[-ipadd] PPPTemplate=0..31
[NUMber={OFF|ON|STARTup}] [PRE13={OFF|ON}]
[PROXYAuth={OFF|ON}]
[TOSreflect={OFF|ON|False|True|NO|YES}]
disable l2tp debug
Syntax DISable L2TP DEBug={ALL|DECode|PKT|STAte}
[CALL[=1..65535]|TUNnel[=1..65535]]
Parameter Description
PROXYAuth Whether the router or switch, acting as an LNS, performs Proxy
Authentication of the PPP user if the LAC provides Authentication
information.
Default: on
ON The LNS performs Proxy Authentication.
OFF The LNS does not perform Proxy Authentication.
Parameter Description
DEBug The debugging options to disable on the specified call or tunnel, or on
all calls and tunnels.
Default: no default
DECode Decode debugging is disabled. When enabled, this
decodes control messages and payload message
headers into a human-readable format.