Allied Telesis RAPIER I - Manual (Page 152)

152 Secure Copy (SCP) Release Note
Software Version 2.8.1
C613-10477-00 REV B
set ssh server
Syntax SET SSH SERver [HOSTKey=key-id] [SERVERKey=key-id]
[EXPirytime=0..168] [IDLEtimeout=0..4294967295]
[LOGintimeout=1..600] [MAXSessions=0..6]
[SCP={ENAbled|DISabled}]
Description This command modifies the configuration of the Secure Shell server. The new
scp
parameter allows you to enable or disable Secure Copy service.
show loader
Syntax SHow LOAder
Description This command displays defaults for the loader and the progress of the current
load.
Figure 45: Example output from the show loader command
Parameter Description
SCP Whether the SSH server supports SCP connections.
Default: enabled
ENAbled Allows SCP connections.
DISabled Does not allow SCP connections.
Loader Information
-----------------------------------------------------------
Defaults:
Method ............. SCP
File ............... -
Destination File.... -
Server ............. 192.168.1.1
HTTP Proxy ......... -
Proxy Port ......... Default ( 80 )
Username ........... alice
Asyn ............... -
Destination ........ Flash
Delay (sec) ........ 0
Current Load:
Method.............. SCP
.
.
.
Table 35: Modified parameters in output of the show loader command
Parameter Meaning
Method Method used to load files, one of: HTTP, SCP, TFTP, WEB, WWW,
ZMODEM, or None.
Server IP address or host name of the server. Used when method is set
to SCP, TFTP or HTTP.
Username The username set for the load or upload. This will only display if
a username has been set.