Allied Telesis RAPIER I - Manual (Page 49)

Software Version 2.8.1 49
Software Version 2.8.1
C613-10477-00 REV B
■ If the acinterface parameter is omitted, the service is mapped to its
corresponding interface (if one exists).
If multiple interfaces exist for the service, you are asked to specify an
acinterface
. The default for this parameter is none.
The acinterface parameter supercedes the now deprecated vlan parameter in
this command.
show ppp pppoe
Syntax SHow PPP PPPOE
Description This command displays information about PPPoE interfaces and services that
are currently configured.
Figure 11: Example output from the show ppp pppoe command
PPPOE
------------------------------------------------------------
PPP1:
Service Name ................. bob
Peer Mac Address ............. 00-00-cd-00-ab-a3
Interface .................... eth0
Session ID ................... a1a3
Maximum Segment Size ......... 1292
Access Concentrator Mode ..... Enabled
Services:
bob
Max sessions ................ 2
Current Sessions ............ 1
Template .................... 1
Interface ................... eth1
MAC RADIUS Authentication ... YES
carol
Max sessions ................ 5
Current Sessions ............ 0
Template .................... 1
Interface ................... vlan1
MAC RADIUS Authentication ... YES
PPPOE Counters:
Rejected PADI packets ...... 0
Rejected PADO packets ...... 0
Rejected PADR packets ...... 0
Rejected PADS packets ...... 0
Rejected PADT packets ...... 0
-----------------------------------------------------------
Table 10: New parameter in output of the show ppp pppoe command
Parameter Meaning
Interface The interface that the PPPoE Access Concentrator or
PPPoE Client is using. If all Ethernet interfaces are being
used, “ethernet" will be displayed.