Allied Telesis RAPIER I - Manual (Page 54)

54 Asynchronous Port Enhancement Release Note
Software Version 2.8.1
C613-10477-00 REV B
Figure 13: Example output from the show asyn=port-number command
ASYN 0 : 0003896346 seconds Last change at: 0000000000 seconds
ASYN information
Name ...................... Asyn 0
Status .................... enabled
Mode ...................... Ten
Data rate ................. 9600
Parity .................... none
Data bits ................. 8
Stop bits ................. 1
Test mode ................. no
In flow state (mode) ...... on (Hardware)
Out flow state (mode) ..... off (Hardware)
Autobaud mode ............. disabled
Max tx queue length ....... 16
TX queue length ........... 3
Transmit frame ............ none
RX queue length ........... 0
IP address ................ none
Max transmission unit ..... 1500
Ten timer value ........... 100
.
.
.
Table 12: New parameters in the output of the show asyn=port-number command
Parameter Meaning
Ten timer value The length of the ten timer, in milliseconds. When an asynchronous port
is in ten mode, it bundles together the characters that it receives within
a certain time period, instead of passing them one at a time to a higher
protocol layer for processing. The ten timer sets the time period over
which characters are bundled.