Allied Telesis RAPIER I - Manual (Page 163)

Software Version 2.8.1 163
Software Version 2.8.1
C613-10477-00 REV B
show firewall
SHow FIREwall
Description This command displays a summary of all security policies that have been
created and the interfaces assigned to each policy.
Figure 51: Example output from the show firewall command
show firewall policy
Syntax SHow FIREwall POLIcy[=policy-name] [COUnter]
[RUle=rule-id[-rule-id]] [SUMmary]
where rule-id is a number or range from 1 to 4294967295
Description This new command displays detailed information about the specified policy or
all policies. The new rule parameter allows you to display only a specific rule,
or subset of rules, for each policy.
Firewall Configuration
Status .................... enabled
Enabled Notify Options .... all
Notify Port ............... 1
Notify Mail To ............ [email protected]
Maximum Packet Fragments .. 20
Sessions:
Maximum ................. 4000
Peak .................... 2589
Active .................. 400
.
.
.
Table 42: New parameters in output of the show firewall command
Parameter Meaning
Sessions Information about the firewall sessions.
Maximum The maximum number of sessions that will be permitted
though the firewall.
Peak Peak usage: the maximum number of active sessions that
have been opened at one time.
Active The number of sessions currently in use.