Allied Telesis RAPIER I User Manual
Page 124
124
Extension to Range of Classifier fields for x900 Switches
Release Note
Software Version 2.8.1
C613-10477-00 REV B
IGMP Type
The IGMP message type to match against the IGMP type field in an IGMP
packet header. A hexadecimal value is shown, with an equivalent
parameter option in brackets if available.
TCP Flags
TCP data flow only. A series of letters representing the TCP/IP flag field,
one of URG, ACK, RST, SYN, or FIN.
Layer 3 Byte 01
to Layer 3 Byte
16
Each Layer 3 Byte field specifies the properties of a single byte field to
match in the Layer 3 part of non-IPv4 and IPv6 packets.
Offset
The offset of a byte from the start of Layer 3. This specifies the location
of the byte to match.
Value
The hexadecimal value to match at the location specified by Offset.
Mask
A hexadecimal number that specifies an eight-bit binary mask to apply to
the value before determining a match. A 1 in the mask means that the
value of the bit in that position is used to determine a match, and a 0
means that the bit is ignored.
Table 30: New parameters in output of the show classifier command (cont.)
Parameter
Meaning