Allied Telesis RAPIER I - Manual (Page 222)

24 enable epsr debug Software Reference
enable epsr debug
Syntax ENAble EPSR={epsr-name|ALL} DEBug={INFo|MSG|PKT|STAte|ALL}
[OUTput=CONsole] [TIMEOut={1..4000000000|NONE}]
Description This command enables debugging for either the selected EPSR instance, or all
EPSR instances.
Examples To enable all debugging modes on the EPSR instance called blue, use the
command:
ena epsr=blue deb=all
Related Commands disable epsr debug
show epsr debug
Parameter Description
EPSR The EPSR instance whose debugging is to be enabled.
Default: no default
epsr-name The name of the EPSR instance. This can be a character
string, 1 to 15 characters long. Valid characters are
uppercase letters (A-Z), lowercase letters (a-z), digits (0-9),
the underscore character ("_"), the hyphen character ("-").
The epsr-name cannot be ALL.
ALL All EPSR instances.
DEbug The debugging modes to be enabled.
Default: no default.
INFo General information about the EPSR instance selected.
MSG Decoded display of received and transmitted EPSR frames.
PKT Raw ASCII display of received and transmitted EPSR frames.
STAte EPSR state transitions.
ALL All debug options.
OUTput When this parameter is set to console, all debugging information will be
sent to the console. By default, the debugging data is sent to the port that
received the enable epsr debug command. Use this option if the enable
epsr debug command is used in a script, because a script is not received
on a port.
TIMEOut The number of seconds during which debugging is enabled on the
specified EPSR instances. Limiting the debugging period reduces the risk of
overloading the switch with debugging information. This value set in this
command overrides all previous EPSR debugging timeout values for the
specified EPSR instances, even if they were specified for other debugging
modes.
Default: the most recent timeout value set in an enable epsr debug
command for the given EPSR instance, or none if none had been set.