Allied Telesis RAPIER I - Manual (Page 28)

28 Switching Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
To view details about disabled ports for VLANs, use one of the commands:
show vlan[={vlan-name|1..4094|all}]
show vlan[=all]
Re-enabling a port When a port is disabled, either completely or for a specific VLAN, it remains
disabled until it is manually re-enabled in any of the following ways:
■ with SNMP
■ as the result of a reboot
■ by specifying a thrash timeout value along with the thrash action
■ via the CLI
If the vlandisable thrash action has been applied, to re-enable one or more
ports from VLANs to which they belong, use the command:
enable switch port={port-list|all}
vlan[={vlan-name|1..4094|all}]
If either the portdisable or linkdown thrash action has been applied, to
re-enable one or more ports, use the command:
If the learndisable thrash action has been applied, the port is automatically
re-enabled when the defined timeout expires. You cannot manually re-enable
the port.
Port Types Limiting rapid MAC movement is supported on all port types. It is also
supported on trunked ports.
Command Changes
The following table summarises the new and modified commands:
Command Change
create switch trunk New thrashaction parameter.
New thrashtimeout parameter.
enable switch port vlan New command.
enable switch port vlan New command.
set lacp New thrashaction parameter.
New thrashtimeout parameter.
set switch port New thrashaction parameter.
New thrashtimeout parameter.
New vlanstatustrap parameter.
set switch thrashlimit New command.
set switch trunk New thrashaction parameter.
New thrashtimeout parameter.
show lacp New address learn thrash action parameter.
New address learn thrash timeout parameter.
show switch port New address learn thrash status parameter.
New address learn thrash action parameter.
New address learn thrash timeout parameter.
New vlan status trap parameter.